Helping You Connect the Dots to Succeed Faster
WGAN-TV: Now Playing
WGAN-TV: Now Playing
Get access to the We Get Around Network Map of Matterport Pro3 Service Providers – and permission to post Help Wanted ads in the We Get Around Network Forum.
Join WGAN Help Wanted Marketing Partner
MSP? Get on the WGAN Pro3 Map
A Service of We Get Around Network (not affiliated with Matterport).
One Order  |  One Quote  |  One Contact
Book Multiple GLOBAL Commercial Locations
  • ✔  As-Builts
  • ✔  Construction Progress
  • ✔  Facilities Management
Last 24 Hours: 203 Unique Visitors
9,359 WGAN Members in 149 Countries
Last 30 Days: 19,738 Page Views | 9,618 Unique Visitors | 13 New Members
We Get Around Network Forum
Quick Start | WGAN Forum
AdviceCapture 2.xProblemsScanningTrim

First Complete Test Scan 5000+ sq ft225

EscapeVelocity private msg quote post Address this user
I finally got my camera and then had to wait several days for my schedule to open up to try it. Comments are welcome but I'm really hoping for some explanations and guidance.

The dining room chandelier is torn at the top in most of the scans around the area also parts of the dining table show similar issues. The kitchen light and island counter top show the same issues.

Why?

I tried doing some outside patio sweeps but it was too bright I think. You can't go out the door to the patio but instead have to hit the circle on the far right of the door to go outside. Once outside you can go back inside without any problem.

What did I do wrong?

And finally - the trim tool sucks! Why is it when you make a line active you move the non-active trim line near it? UGH!!




FYI the model will only be up for a little while. I was allowed to do this but only as a test.
Post 1 IP   flag post
EscapeVelocity private msg quote post Address this user
Support responded that there's a bug in the trim tool. Engineering is going to look into the tearing issue.
Post 2 IP   flag post
105439 2 2
This topic is archived. Start new topic?