Ricoh Z1 Matterport - alignment issue17440
Pages:
1
|
sdubose99 private msg quote post Address this user | |
Is this a problem with my camera, or... what else could it be? Matterport with Ricoh Theta Z1. |
||
| Post 1 • IP flag post | ||
 WGANPremium Member Lahaina, Hawaii |
Skeeter private msg quote post Address this user | |
| Usually you get that kind of stuff with the pro 2 when it's to close. I never had it happen with z1. | ||
| Post 2 • IP flag post | ||
|
ron0987 private msg quote post Address this user | |
| Was it possible that it is where the two spheres were stitched together and being near the wall? | ||
| Post 3 • IP flag post | ||
 WGAN ForumFounder & WGAN-TV Podcast Host Atlanta, Georgia |
DanSmigrod private msg quote post Address this user | |
| @sdubose99 Did you keep the Ricoh Theta Z1 parallel to the wall (best practice) versus perpendicular (side of camera) towards the wall (likely reason for the stitching problem). The Ricoh Theta Z1 camera orientation matters when the camera is close to walls. Dan |
||
| Post 4 • IP flag post | ||
|
|
sdubose99 private msg quote post Address this user | |
| Hmmm interesting... so if the side of the camera is aimed into the room, it's less likely to have stitching issues? I'll look into that... makes sense. Thanks Dan | ||
| Post 5 • IP flag post | ||
|
WGAN Forum Founder & WGAN-TV Podcast Host Atlanta, Georgia |
DanSmigrod private msg quote post Address this user | |
Quote:Originally Posted by sdubose99 Yes! Nothing to stitch on the wall: just stitching between the two lenses down/up the hallway. Because that's in the distance, you will not see bad stitching. Dan |
||
| Post 6 • IP flag post | ||
Pages:
1This topic is archived. Start new topic?