Best way to film space with 4 floors that only connect on ground level?14096
Pages:
1
|
Virtour private msg quote post Address this user | |
| Our team is filming a school that has 2 wings - East and West. The ground-level floor of the school spans the width of both wings. The East Wing has 3 floors above ground level and those are only accessible by staircase A. The West Wing has 2 floors above ground level and those are only accessible by staircase B. The concern is that the spaces will not align if they can't be connected on the second and third levels between the two wings. Any suggestions/best practices to get this all populated in one Matterport model? Thanks in advance, Noah |
||
| Post 1 • IP flag post | ||
 WGANStandard Member Los Angeles |
Home3D private msg quote post Address this user | |
| Just very generic advice here. Scan the along the routes you have, but throughout all doorways and stairwells keep an eagle eye on the mini-map as each new scan aligns. If any NEW wall data appears which is out of the 90° alignment (presuming it's a typical building in this way) then delete the scan immediately and try again. Also, if ANY scan on these connecting pathways give you a "Low Scan Overlap" (I think that's the name), DELETE, do not accept, the scan. Then reduce the distance from previous and try again until you don't get this warning. That's the best key to making sure everything stays at proper 90° angles, or close enough that the Matterport processing algorithm will straighten it out. | ||
| Post 2 • IP flag post | ||
 WGAN FanCLUB Member Coeur d'Alene, Idaho |
lilnitsch private msg quote post Address this user | |
| Adding onto @Home3Ds advice I'd also suggest scanning the entire main floor first then, tackle each wings upper floors. So, in short Main floor first, then entire East Wing, then entire West Wing ~ doesn't matter which wing gets scanned first just do those upper floors in entirety before capturing the other wing |
||
| Post 3 • IP flag post | ||
 WGANStandard Member Cayman Islands |
Harrycayman private msg quote post Address this user | |
| i just did a school where i connected the ground floor buildings and then had second floor of each building just named it floor 3 and matterport put it in right floor for each separate building . But yes do not accept any low scan overlaps. | ||
| Post 4 • IP flag post | ||
|
|
Virtour private msg quote post Address this user | |
| Thank you @Home3D , @lilnitsch , and @Harrycayman ! Much appreciate the advice and insight - will keep you posted on how it turns out! |
||
| Post 5 • IP flag post | ||
 WGAN ForumFounder & WGAN-TV Podcast Host Atlanta, Georgia |
DanSmigrod private msg quote post Address this user | |
| @Virtour Thanks for sharing the tour here, once done (plus, how you accomplished it). Best, Dan |
||
| Post 6 • IP flag post | ||
Pages:
1This topic is archived. Start new topic?